1.Please disassemble the original metal swashplate ,and toast the joint of the base and the bearing with a lighter for 15 seconds. It makes more easiler to disassemble. For the safety issue, please wear cotton gloves when you are near the flames.
2.Put a screw driver(#101 for the best size) through the bearing and the handle stock on the base.
3.Hold the base of swashplate by one hand and knock on the screw driver the other hand by the other hand for making the base and bearing separate.
4.Use Knife to clean up the remain of glue R48 on the bearing.
5.Apply glue R48 on inside of the bearing.
6.Insert a brand new ball bearing set into the bearing and then wipe surplus off. After that, inspect if the assembly is in a correct angle and keep it horizontally until next day. Finally, assemble it into your heli and fly.
●Use for swashplate(V2)
●Grommet is made of nylon with MoS2.It Features wear-resisting and smooth for quick movement of swashplate. It improve control precision and lifetime.
●Metal cover x 1
●Metal stand x 1
●Grommet x 2
●Stainless steel linkage ball x 4
●Cross screw x 4(M2x6.5)
●Ball bearing x 1(Φ5xΦ10x7mm)
